Today, I will discuss two functions in release 2020.1 of the Spacecraft Control Toolbox (SCT) which can be used to get your spacecraft into a lunar orbit. They are LunarTargeting.m and LunarMissionControl.m. They are demonstrated together in the script LunarMission.m.

LunarTargeting.m produces a transfer orbit that starts at a Low Earth Orbit (LEO) altitude and ends up passing by the Moon with a specified perilune (periapsis of the Moon) and lunar orbital inclination. Its novel approach to the patched-conic-sections model of multibody orbital transfers uses the solution to Lambert’s problem to target a point on the gravitational boundary between the Earth and the Moon. Then it numerically optimizes over points on that surface until the initial velocity of the transfer is minimized. LunarTargeting.m requires the MATLAB optimization toolbox.

LunarMissionControl.m implements a control system which enables a spacecraft to propulsively enter lunar orbit. Like the other control systems implemented in the SCT, it stores its active state and degrees of freedom in a data structure, and accepts a list of commands as arguments. The commands we’ll see used here are ‘initialize,’ ‘lunar orbit insertion prepare,’ ‘align for lunar insertion,’ and ‘start main engine.’

LunarMission.m ties them both together and simulates a spacecraft, down to the attitude-control level. The simulation includes power and thermal models. The spacecraft can be controlled by reaction wheels or thrusters. Forces from the Sun, Earth, and Moon are included. The spacecraft starts on the trajectory returned by LunarTargeting.m, then acts in accordance to commands to LunarMissionControl.m. It takes the spacecraft 4.5 days to get to perilune, at which point it inserts itself into lunar orbit. Let’s take a look!

Take a look at the above figure. This is the entire mission trajectory in the Earth-Centered Inertial (ECI) frame. We can see the initial transfer orbit as the red line. Then it approaches the blue line (the Moon’s orbit), and begins corkscrewing around it after orbital insertion. Let’s look at that insertion in close-up:

The above figure shows the final part of the trajectory in Moon-centered coordinates. The red line starts as the spacecraft passes the imaginary gravitational boundary between the Earth and the Moon. It falls closer to the Moon, and at its closest point, fires its engines to reduce its velocity. You can’t see it in this figure, but that process is actually resolved on a 2 second timescale. The spacecraft is commanded to point retrograde using a PID controller, waits until it has pointed correctly, then fires its engines for a prescribed duration. If you look closely, you will see that moon has a 3 dimension surface courtesy of the Clementine mission.

Let’s finish this post off with some technical details:

On the far left, you can see the reaction wheel rates. They stay at zero for 4.5 days, as the spacecraft coasts. Then, when the craft is commanded to point retrograde for its orbital insertion, you can see wheels 2 and 3 spin up. Wheel 1 stays near zero; its vertical scale is 10^-16. Then in the center, you can see fuel use. The only fuel use is the insertion burn, so fuel stays constant until 4.5 days in. Less than 2 kg of fuel is used for this example, as the spacecraft is a 6U cubesat. On the right, the components of the body quaternion are displayed. Again, they are constant until 4.5 days in, when the craft is commanded to point retrograde.

I hope you’ve enjoyed this demonstration of how to simulate a lunar mission with the SCT! For more information on our toolboxes check out our Spacecraft Control Toolbox for MATLAB. You can contact us directly by email if you have any questions.

je utilise cet logiciel pour me PFE

je utilise cet logiciel pour me PFE

Hello! Can I help in some way?